product reference catalogue
Service Guides | Select Slab Hood Motor Replacement
Stacks Image 381
Step 1
  • • Ensure that the appliance is switched off and unplugged from the mains.
  • • Remove the grease filters from the bottom of the hood.
  • • Remove the entire hood from the wall.

Step 2

  • • Place the hood on it's back so that you can easily access the top and bottom of the hood.

  • • Disconnect the motor from the power supply as shown.


Stacks Image 403
Stacks Image 416
Step 3
  • • Remove all of the screws holding the motor in place at the top of the hood.
  • • With these removed the motor will become free and can be removed through the bottom of the hood where the grease filters were located.

Step 4

  • • With the motor removed, install a new one by following the instructions above in reverse.

  • • During installation, ensure that no objects fall in to the motor as this could cause damage when it is turned on.

Stacks Image 433
Bigblue Product Design Limited
1 Colchester House
The Square, Seller Street
Chester
CH1 3AP
United Kingdom

phone: 01244 402975