product reference catalogue
Service Guides | Select Slab Hood Light Replacement
Step 1
- • Ensure that the appliance is switched off and unplugged from the mains.
- • Remove the grease filters from the bottom of the hood.
Step 2
• Feel around the back of the light to find a cable connected to the rear of the lighting assembly, as shown.
• Disconnect the cable to free the lighting assembly from the electrical system.
Step 3
- • Behind the back of the lighting assembly you will feel two compression clips on either side of the light.
- • Squeeze these together to release the lighting assembly through the bottom of the hood.
Step 4
• When doing this be careful not to allow the lighting assembly to drop as this could cause the glass to break.
Step 5
- • To remove the bulb from the lighting assembly you will need a flat screwdriver.
- • Insert the screwdriver into the circlip located around the outside of the lights glass
- • Rotate around the cir clip and the glass will pop out revealing the bulb.
- • Depending on the age of your hood, the bulbs may vary. Replace your broken bulb with another that matches the existing bulbs specifications (Usually printed on the bulbs glass).
Bigblue Product Design Limited
1 Colchester House
The Square, Seller Street
Chester
CH1 3AP
United Kingdom
1 Colchester House
The Square, Seller Street
Chester
CH1 3AP
United Kingdom
phone: 01244 402975